Author Topic: Alloys to fit Mercedes 190 (Fox R1, 15")  (Read 403 times)

0 Members and 1 Guest are viewing this topic.

Offline Tim

  • Lo-rdz club member
  • Regular
  • **
  • Posts: 270
    • http://www.chinashopbull.com
Alloys to fit Mercedes 190 (Fox R1, 15")
« on: March 14, 2009, 11:10:11 PM »
Hello folks,

Selling the alloys from my 190.

4 of these with near new condition rubber:



In Bristol. Can courier - would charge it on at cost.

Discussion starts at £225

Tim
http://www.chinashopbull.com

Project: 1994 Vitara .. 3 pumps .. 4 batteries .. Multi tone 14s .. A million LEDs


Offline vwbeetle

  • Regular
  • *
  • Posts: 238
Re: Alloys to fit Mercedes 190 (Fox R1, 15")
« Reply #1 on: March 15, 2009, 10:41:42 PM »
whats PCD on a 190? also whats offset and load rate of wheel please

Offline ant

  • Lo-rdz club member
  • Regular
  • **
  • Posts: 1488
Re: Alloys to fit Mercedes 190 (Fox R1, 15")
« Reply #2 on: March 16, 2009, 05:33:24 PM »
5x112
Need whitewalls? redwalls?

http://www.mrwhitewalls.com

Offline Tim

  • Lo-rdz club member
  • Regular
  • **
  • Posts: 270
    • http://www.chinashopbull.com
Re: Alloys to fit Mercedes 190 (Fox R1, 15")
« Reply #3 on: March 26, 2009, 11:00:23 PM »
Thanks Ant - VW Beetle - load rate? Erm .. you probably need to contact Fox for that... what are you planning to run them on !?!?!
http://www.chinashopbull.com

Project: 1994 Vitara .. 3 pumps .. 4 batteries .. Multi tone 14s .. A million LEDs


Offline vwbeetle

  • Regular
  • *
  • Posts: 238
Re: Alloys to fit Mercedes 190 (Fox R1, 15")
« Reply #4 on: March 27, 2009, 02:53:35 PM »
Just thinking about poss sticking on van as the van original wheels are 15's and with the van tyres for a bit of comfort, i.e what i use for winter. The 18" with low profiles r very hard ride and with the pot holes getting bigger and more common might swap back to 15" just got to find out what the original ET is as the old 15" alloys i had on it before Juice wont fit due to them not clearing the arch's when dropped.